Reltio Connect

Hey all, I am doing a feasibility check for this below scenario.

I have an attribute called AttributeA whose values should be populated based on the lookup assigned to another attribute called AttributeB.

Is this achievable? If yes, please share the relevant Data Modeler and L3 configuration capabilities/steps to do the same please.

Thanks in advance.

Hi Nidheesh,

Yes this can be achievable.

First you need to configure Dependent Lookup in L3 Config and Parent Lookup in RDM.

Thanks for your reply Karthik. Actually, this is the actual question I wanted to check.

1. I have an attribute called AttributeA which should be populated based on lookupcode assigned to another attribute AttributeB(I dont want to lookups of AttributeB to be directly used by AttributeA). Or, 

2. The value of AttributeA should be using the value of AttributeB as its lookup.

As you said, if this is achievable, I've not used this parent-dependent lookup so far. Do you mind sharing a piece of sample config on how it can be done?

------------------------------
Nidheesh R
------------------------------

Hi Nidheesh,

I believe the sample lookup structure you are looking for can be found here: 

https://docs.reltio.com/en/explore/get-a-crash-course/get-ready-to-turn-your-data-into-action/learn-about-multidomain-mdm/lookups-for-attribute-code-values/dependent-lookups

Hope this document provides the guidance you were looking for.